Chicken water feeder hanging how to#
You probably can figure out how to screw it in! Not a big deal, but something to consider when you decide on a height.Īs there isn’t a lot to really discuss here… well… here’s some photos. This year I discovered that my feeders touch the ground with all of the extra chips I added so I’ll need to remove the brackets to raise them again. The wood chips compost down, but it’s still a pretty thick layer of wood chips.
I use woodchips in my chicken run so I usually add more twice a year to freshen things up. Just keep in mind when choosing a height that your chickens can reach a bit higher than you might expect, and if you plan to add more ground cover to your chicken run, you need to account for that extra dirt/sand/etc. The feeder/waterer should NOT be sitting on the ground.
Chicken water feeder hanging full#
Place your feeder on the hook and see how high you need them to be you want the full weight of the feeder/waterer supported by the brackets. When hanging these, make sure you’re attaching them to a sturdy wood post. I prefer the GRX or Spax screws, but make sure you get the right size and exterior grade screws. If you’re not familiar with screw heads, Phillips head are more prone to stripping than a square or star head screw. I managed to strip a couple of screws in the process of installing these so I’d definitely use a higher quality screw head next time. While these look nice and have held up well, I HATED the Phillips head screws that they came with. These are 12″ and seem sturdy enough to hold the water and feed. Please read the whole post so you don’t miss any important information!įirst, I picked up a 4 pack of plant brackets.
As an affiliate for Amazon, Cricut, xTool, Home Depot, and other sites, I earn from qualifying purchases. This post may contain affiliate links which may earn me commissions should you click through them and take certain actions. I figured I would give these brackets a try and they look great! Usually the waterers spill less if you have them balanced nicely from above, but we feed our chickens and ducks in the run– not the coop- and our run doesn’t have a sturdy post overhead to hang feeders from. We’ve been placing them on the ground which works fine, but they tend to kick dirt into their water and feed. I’ve seen some photos going around Pinterest of people who used plant brackets to hang their feeders and waterers for their chickens. These 12″ planter brackets are perfect for supporting water and feed! How to pasture on a small lot.How to hang your chicken waterer and feeder in your chicken run. Here are a few more instructables I put together on raising chickens: Building a chicken coop and getting setup with a new set of ladies was the first thing we did at our new house. The goal is to make it easier for others to start raising backyard chickens. During the winter months it would become more of an issue as they get bored.
With four places the girls can all get at the feed and have some separation. Hanging from a simple piece of twine helps a lot.Īlso great to not have them bullying each other as they eat. They find it easy to get through the chicken wire and into the food. In the past we've always dealt with chipmunks and mice that will come to steal good. The ladies are happy with the trough and I'm thrilled to have their food off the ground!
0 kommentar(er)
